Finally, you need to connect the 'Trp' terminal on the TG-1 to one of the 'AUXOUT' terminals on the NX-8. The zone used must be one of the eight on-board wired zones and you cannot use an expansion zone for this connection.

Then, you need to wire the two 'STC' terminals on the TG-1 to an open zone on the control panel. With the NX-8, you need to connect the 'Gnd' terminal on the TG-1 to the auxiliary power 'COM' terminal on the NX-8 and the 'Pwr' terminal on the TG-1 to the 'AUX +' terminal on the NX-8. Telguard Interactive service works by wiring the TG-1 Express universal cellular alarm communicator to the alarm control panel.

While Telular does a good job of providing detailed installation instructions for integrating their cellular alarm communicators with most alarm control panels, the instructions for the newer NX-6 control panel were not working for this older NX-8 and therefore, the system wasn't acting as it should. Fresh off the heels of our Telular partnership, we had an interesting situation come up when trying to provide the Telguard Interactive service to one of our new customers that had an existing GE NetworX NX-8 control panel.

Networx nx 6 access control